Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
INTRODUCTION
Accurately form metal boxes, covers, trays and more with this aluminum
bench-top bending brake. It bends 14-gauge metal up to 90° and includes
holes in the base for quick, easy mounting.
SAFETY
WARNING! Read and understand all instructions before using this tool. The
operator must follow basic precautions to reduce the risk of personal injury
and/or damage to the equipment.
Keep this manual for safety warnings, precautions, operating or inspection
and maintenance instructions.
WORK AREA
1.
Operate in a safe work environment. Keep your work area clean, well-lit
and free of distractions. Place lights so you are not working in a shadow.
2.
Keep anyone not wearing the appropriate safety equipment away from
the work area.
3.
Store unused tools properly in a safe and dry location to prevent rust
or damage. Lock tools away and keep out of the reach of children.
PERSONAL SAFETY
WARNING! Wear personal protective equipment approved by the Canadian
Standards Association (CSA) or American National Standards Institute (ANSI).
PERSONAL PROTECTIVE EQUIPMENT
1.
Always wear impact safety goggles that provide front and side protection
for the eyes. Eye protection equipment should comply with CSA Z94.3-07
or ANSI Z87.1 standards based on the type of work performed.
2.
Wear the appropriate type of full-face shield in addition to safety
googles, as the work can create chips, abrasive or particulate matter.
3.
Wear gloves that provide protection based on the work materials or to
reduce the effects of tool vibration.
4.
Wear protective clothing designed for the work environment and tool.
5.
Non-skid footwear is recommended to maintain footing and balance in
the work environment.
6.
Wear steel toe footwear or steel toe caps to prevent a foot injury from
falling objects.
Visit www.princessauto.com for more information
48 in. Bench-Top Metal-Bending Brake
9036120
3
Publicité
Table des Matières
