Ribimex PRTMEMIX400 Manuel D'instructions Et D'utilisation page 14

demages, flaws or cracks.
• Restore the flange and locking nut then tighten. Do not overtighten to avoid damage to the
grinding wheel.
• Rotate the grinding wheel by hand to make sure it moves freely and doesn't in contact with
any foreign objects.
• Slightly grease the metal parts to prevent corrosion.
• Re-assemble the water container and restore the drain bung.
• Fill the water container with clean water up to 1/3 of the grinding wheel diameter.
Fig. 5a
4.3- Switch On/Off
• Connect the tool to the main power source.
• To start the machine, set the power switch (3) to "I" position.
• To stop the machine, set the power switch (3) to "O" position.
Fig. 5b
Fig. 5c
Page 14 / 25