Important Safeguards - Tribest dynablend clean Mode D'emploi

IMPORTANT SAFEGUARDS

When using electrical appliances, the following basic safety precautions
should always be adhered to:
1. Read all instructions.
2. Avoid electrical shock: do not put cord plug, base, or motor in water or other liquid;
never put a wet plug into a socket, or handle with wet hands; never immerse the
Motor Base in water. Wipe with a damp cloth only and dry promptly.
3. Close supervision is necessary when any appliance is used near children. Children
under the age of 12m should not use this machine without adult supervision.
4. Unplug from the outlet when not in use, before putting on or taking off parts, and
before cleaning.
5. Blades are sharp, handle carefully. Avoid all contact when parts are still moving.
6. Always use on a level, sturdy surface.
7. Do not use outdoors.
8. Do not operate while driving a vehicle.
9. Do not operate any appliance with a damaged cord or plug. If the Dynablend
Clean malfunctions, is dropped, or damaged in any manner, call the Main Service
Center (888-254-7336) to get a Return Merchandise Authorization (RMA) No. prior
to sending your Dynablend Clean to the service center. Returns will not be accepted
without a RMA No. clearly written on the box.
10. Only use attachments sold by Tribest with the Motor Base. The use of attachments,
including canning jars, is not recommended by the manufacturer and may cause
injury to persons or damage to the Dynablend Clean.
11. Do not let cord hang over an edge of a table or a counter, or touch the stove or
other hot surfaces.
12. To avoid injury, properly attach the Stainless Steel Blade Assembly to the Glass
Pitcher base.
13. Do not blend liquids over 104°F. When blending hot liquids, remove center piece of
the two-piece lid.
14. Only use the Dynablend Clean for its intended purpose. For Household use only. Not
for commercial use.
15. Wash the Glass Pitcher and Stainless Steel Blade Assembly immediately after each
use.
16. In 30 second Pulse mode, always allow the machine to rest for at least one minute
between consecutive blending cycles of 30 seconds. When blending in the 60-
second cycles, 60 second Blend or Combo mode, do not exceed 3 consecutive cycles
17. Store the Glass Pitcher with its Lid. Make sure the parts are thoroughly dry.
18. The Dynablend Clean has a polarized plug. To reduce the risk of electric shock, this
plug will fit in a polarized outlet in only one way. If the plug does not fit properly in
the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do
8