Tribest dynablend clean Mode D'emploi page 15

How to Remove Stainless Steel Blade Assembly from the Glass Pitcher
1. Place the Glass Pitcher upside down on
a counter.
2. Align ridges on the Blade Opener to the
grooves on the Stainless Steel Blade Assembly (as
shown in Green).
3. Unlock the Stainless Steel Blade Assembly by turning
the Blade Opener counter-clockwise.
4. Make sure to check and see whether the
Stainless Steel Blade Assembly has been released
from the locked position to unlocked position
(as shown in Orange).
5. Cover the bottom of the Glass Pitcher with your palm
and turn the Glass Pitcher right side up. The
Stainless Steel Blade Assembly will easily detach.
WARNING: The blade is sharp. Do not touch
to avoid cutting yourself. Do not leave it in
soapy water where it may not be visible.
NOTE:
Additionally, you may use the inside
of the Lid as a blade opener. Align the
inside of the Lid Cap opening with the
Blade Assembly and turn counter-clockwise.
How to Reassemble the Blade Assembly
1. Place the Silicone Seal at the ridge of the
Glass Pitcher.
2. Place the Blade Assembly in its place over the
Silicone Seal and turn it clockwise to its locked
position using the Blade Opener.
STORAGE
1. Place your Tribest Dynablend Clean on the kitchen counter so that its easily accessible.
2. Keep it unplugged when it is not in use.
3. If you keep your Stainless Steel Blade Assembly disassembled, please store it in a
convenient, safe place out of the reach of children, as you would with sharp knives.
Locked
Unlocked
EN
15