Measuring - TESTO 926 Mode D'emploi

6. Measuring

34
6. Measuring
This chapter describes the steps that are required to
perform measurements with the product.
The instrument is switched on and is in measurement
view.
Taking a a m m easurement:
Put the probe in position and read off the readings.
With the Auto Hold function on:
The Auto Hold function is only active on plug-in
measuring probes.
- Auto Hold flashes during measurement.
- If the reading is stable within the set evaluation
time, a signal tone is given and the reading is
recorded.
With the alarm function on and if the alarm threshold
is exceeded or not undershot:
- Alarm lights up and a signal tone is given.
- The alarm goes out if the reading goes below the
upper or above the lower threshold again.
Changing t t he m m easurement c c hannel d d isplay:
You can change between displaying plugged-in probes
and radio probes ( ).
To change the display: Press
Holding t t he r r eading, d d isplaying t t he m m aximum/minimum
value:
The current reading can be recorded. The maximum and
minimum values (since the instrument was last switched
on) can be displayed.
Start measurement again with .
.