LaserLiner SmartCross-Laser Mode D'emploi page 5

Read the operating instructions and the enclosed brochure „Guarantee and
!
additional notices" completely. Follow the instructions they contain. Safely
keep these documents for future reference.
The automatic cross-line laser for aligning tiles, wall studding, windows,
doors etc.
General safety instructions
Do not stare into the beam!
Caution: Do not look directly into the beam. Lasers must be kept out of reach of children.
Never intentionally aim the device at people. This is a quality laser measuring device and is
100% factory adjusted within the stated tolerance. For reasons of product liability, we must
also draw your attention to the following: Regularly check the calibration before use, after
transport and after extended periods of storage. We also wish to point out that absolute
calibration is only possible in a specialist workshop. Calibration by yourself is only approxi-
mate and the accuracy of the calibration will depend on the care with which you proceed.
!
Always turn off all lasers and latch the pendulum in place before transporting,
ON/OFF switch in its „OFF" position!
1 Inserting batteries
Open the battery compart-
ment and insert batteries
(2 x type AA) according to
the symbols. Be sure to pay
attention to polarity.
2 Horizontal and vertical levelling
Release the transport restraint, set the ON/OFF switch to „ON". The laser cross will
appear. The laser lines can be switched individually with the selection button.
LASER LASER
The transport restraint must be released for horizontal and vertical levelling. The
LED shows a permanent green light. The laser lines ash and the LED lights red
!
as soon as the device is outside the automatic levelling range of 5°. Position the
device such that it is within the levelling range. The LED switches back to green
and the laser lines stop ashing (steady light).
Laser radiation!
Class 2 laser
< 1 mW · 650 nm
EN 60825-1:2007-10
1
2
3
4
5
6
LASER
–
+
–
1 Laser line selection button
2 LED levelling
red: levelling off
green: levelling on
3 Battery compartment (backside)
4 ON / OFF switch,
transport retainer
5 Laser output windows
6 1/4" tripod threads (bottom)
LASER
SmartCross-Laser
GB 5