Publicité
Les langues disponibles
Les langues disponibles
Use of a ground fault circuit interrupter (residual current device, RCD) with a
maximum tripping current of 30 mA is recommended.
5.1 Switching on charger and charging battery
WARNING
Explosion hazard if any attempt is made to charge unapproved batteries.
Injuries and damage to the charger can result.
▶ Do not attempt to charge non-rechargeable batteries.
▶ Use only Hilti-approved batteries with this charger.
CAUTION
Short-circuit due to moisture or dampness Damage to the product is the
result.
▶ Use the product only indoors.
▶ Keep the product away from moisture and dampness.
1. Plug the supply cord into the power outlet.
▶ The LED shows green.
2. Engage the battery on the battery interface.
▶ The battery is charging.
3. When the battery is fully charged, remove it from the charger.
6
Care and maintenance
WARNING
Electric shock hazard! Attempting care and maintenance with the supply
cord connected to a power outlet can lead to severe injury and burns.
▶ Always unplug the supply cord before carrying out care and maintenance
tasks.
Care
•
Carefully remove stubborn dirt from the tool.
•
Clean the air vents carefully with a dry brush.
•
Use only a slightly damp cloth to clean the casing. Do not use cleaning
agents containing silicone as they can attack the plastic parts.
Maintenance
•
Check all visible parts and controls for signs of damage at regular
intervals and make sure that they all function correctly.
•
Do not operate the product if signs of damage are found or if parts
malfunction. Have it repaired immediately by Hilti Service.
•
After cleaning and maintenance, fit all guards or protective devices and
check that they function correctly.
*2275224*
2275224
English
19
Publicité
