mundoclima MUCR-12-H8 Manuel D'installation Et L'utilisauter page 96

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

WIRED CONTROLLER
Child lock function
Press the button "+" and "-" simultaneously for 3 seconds to activate
the child lock function and lock all buttons on the wire controller.
Press the buttons again for 3 seconds to deactivate the child lock function.
When the child lock function is activated,the
Keypad tone setting
BACK
Press the button "BACK" and "COPY" simultaneously for 3 seconds to
close the keypad tone.
Press the buttons again for 3 seconds to open the keypad tone.
°C & °F scale selection (on some models)
SWING
SWING
Faceplate function (on some models)
1.When the unit is off, Press the Mode(A/B) button long to activate the
faceplate function. The
The F2 mark appears when
the faceplate is adjusted.
2. Push the Mode(A/B) button to select Unit A or Unit B, the wire controller select in a
sequence that goes from (this step do not need to perform if the wire controller is
connected with one unit only):
3. Press the button "+" and "-" to control the lift and drop of the faceplate.
Pressing the "+" button can stop the faceplate,while it is dropping.
Pressing the "-" button can stop the faceplate,while it is lifting.
Left-right airflow swing (on some models)
Press the
button to activate the auto Left-right swing feature of the louver.
And then the louver would swing automatically.Press it again to stop.
When the auto Left-right swing feature of the louver is activated, the
(Not applicable to all the models)
mark appears.
COPY
Press and hold
and
for 3 seconds will alternate the temperature display
between the
scale.
mark will flash.
A
B
buttons together
mark appears.
96

Publicité

Table des Matières
loading

Table des Matières