Tuner; Usb Connection; Hdmi Connection - Pioneer HTZ-360DV Mode D'emploi

09 Additional information
Problem
Can't play WMA or
MPEG-4 AAC files.

Tuner

Problem
Considerable noise in
radio broadcasts.
Auto tuning does not
pick up some stations.

USB connection

Problem
USB mass storage
device is not recognized
by the system.
Files don't show up in
the Navigator/Photo
Browser.
Can't play WMA or
MPEG-4 AAC files.

HDMI connection

Problem
No HDMI audio output.
42
En
Remedy
• The files were recorded using DRM (digital rights management). This is not a
malfunction.
Remedy
• Connect the AM antenna (refer to the Setup Guide) and adjust the direction and
position for best reception. You may also connect an additional internal or external
AM antenna (refer to Connecting auxiliary audio components on page 31).
• Fully extend the FM wire antenna, position for best reception, and secure to a
wall. You may also connect an outdoor FM antenna (see Connecting external
antennas on page 31).
• Turn off other equipment that may be causing the noise or move it further away.
• The tuning interval is incorrect for your country or region. See Frequency
step setting on page 39 to switch the tuning interval.
• The radio signal is weak. Auto tuning will only detect radio stations with a good
signal. For more sensitive tuning, connect an outdoor antenna.
Remedy
• Make sure you have completely inserted the USB connector to this unit.
• Check that the memory format is FAT16 or FAT32.
• USB devices with an internal USB hub are not supported.
• The files must have the correct file extension: .mp3 for MP3 files; .wma for WMA
files; .m4a for MPEG-4 AAC files; .jpg for JPEG files (upper or lower-case is OK).
• Make sure the file permission hasn't been restricted (through a password, etc.).
• The files were recorded using DRM (digital rights management). This is not a
malfunction.
Remedy
• See Switching the HDMI audio setting on page 33 to make sure that AUDIO ON
is selected.