Highchair Assembly; Assemble Seat; Assemble Tray; Assemble Footrest - Jole multiply Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16

Highchair Assembly

Please read all the instructions in this manual before assembling and using this product.

Assemble Seat

see images
-
1
20
Press the folding button to open support legs.
3
19
Fit the seat onto the frame
. An audible "click" means the seat is secured to the frame.
!
Please do not make the webbing which is on the back of seat clamped while attaching the seat, otherwise
the seat can not be attached completely.
19
!
Lift the seat up to be sure it is locked into place.

Assemble Tray

see images
-
21
23

Assemble Footrest

see images
24
The completely assembled highchair is shown as

Highchair Operation

Use Tray

see images
-
26
30
The tray can be adjusted to 4 positions.
Adjust Footrest
see images
31
The footrest can be adjusted to 3 positions.

Adjust Height for Seat

see images
32
The seat can be adjusted to 5 positions.

Adjust Recline

see images
33
The recline can be adjusted to 3 positions.

Adjust Height for Shoulder Harnesses

see images
-
34
38
Note
1. The shoulder harness must go into the slot that is even with or slightly above the shoulders.
2. In order to protect your child from falling out, after your child is placed into the seat, check whether the
shoulder harnesses are at proper height.
25
20
25
- 1
35
Shoulder harness anchor A
- 2
Shoulder harness anchor B
35
- 3
Slide adjuster
35
For larger child, use shoulder harness anchor A and the highest shoulder slots.
For smaller child, use shoulder harness anchor B and the lowest shoulder slots.
Choose a pair of proper shoulder slots. Insert the shoulder harnesses into slots in seat pad and seat back.
36 37 38
!
When changing shoulder harness slots, make sure shoulder harnesses are going through same slots in
seat pad and seat back.

Use Buckle

see images
39
Note
1. To prevent serious injury or death from falling or sliding out, always secure child in the restraint.
2. Make sure the restraint harness is fitted correctly and the space between the harness and the
child does not exceed the thickness of an adult hand.
3. DO NOT cross the shoulder belts. This will cause pressure on child's neck.
Lock Buckle
Match the waist belt buckle up with the shoulder buckle and slide together
- 2
center buckle
. A "click" means the buckle is locked completely
39
Release Buckle
Press the center button to release the buckles.

Adjust Length for Harnesses

see images
40
1. Use slide adjuster to change the harness length.
2. Pull waist harness to tighten to proper length
40

Fold Highchair

see images
-
41
43

Infant Booster Operation

see images
-
44
63
!
The backrest of infant booster can not be reclined when using infant booster with chair.
Please refer to the form data to use the product to avoid it falling and
cause hurting child
Recommended adult chair seat dimensions to be minimum 38cm (width)X44cm (length).
Minimum height of the adult chair´s backrest should be 13cm.
- 1
39
. Insert buckles into the
- 3
.
39
- 1
40
- 2
. Press the button to loosen the waist harness.
47
- 3
40
26

Publicité

Table des Matières
loading

Table des Matières