Skil PWRCORE 20 ID573901 Guide D'utilisation page 14

LED Light
Your tool is equipped with an LED light,
located on the base of the tool. This provides
additional light on the surface of the work piece
for operation in lower-light areas.
The LED light will automatically turn on with a
slight squeeze on the variable-speed trigger
switch before the tool starts running, and will
turn off approximately 10 seconds after the
variable-speed trigger switch is released.
The LED light will rapidly flash when the tool
and/or battery pack becomes overloaded or
too hot, and the internal sensors will turn the
tool off. Rest the tool for a while or place the
tool and battery pack separately under air flow
to cool them.
The LED light will flash more slowly to indicate that the battery is at low-battery capacity.
Recharge the battery pack.
Removable Belt Clip (Fig. 7)
Your tool is equipped with a removable belt clip
that can be positioned on the left side of the
tool for convenient transport.
Install the belt clip onto the tool:
a. Remove the battery pack from the tool.
b. Align the rib of the belt clip with the threaded
hole on the base of the tool.
c. Insert the screw and securely tighten the
screw with a screwdriver.
Remove the belt clip from the tool:
d. Remove the battery pack from the tool.
e. Use a screwdriver to loosen the screw that
attaches the belt clip to the impact driver.
f. Remove the screw and the belt clip.
14
Fig. 6
Fig. 7