W_FLOW1: Water Flow Meter Connector
This connector allows you to connect a water flow meter to monitor the flow rate of
your liquid cooling system.
JLN1: Low Temperature Booting Jumper
This jumper allows liquid nitrogen cooling system to boot at an extremely low
temperature. Please try to enable the jumper to help the system boot successfully.
⚠
Important
∙
Please note that overclocking at an extremely low temperature carries the risk of
system instability and may cause damages to the system.
The overclocking results may vary depending on the CPU you use.
∙
∙
Do not enable the jumper when the system is power off. Otherwise, the system will
be unbootable.
Pin
Signal Name
1
Ground
3
WFLOW IN
Normal
(Please enable this jumper
(Default)
50
1
Pin
Signal Name
2
WFLOW PWR
Enabled
during BIOS POST)