Machine Operation (Scrubbing/Drying) - Nilfisk Advance SC350 Instructions D'utilisation

ENGLISH

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine as shown in the previous paragraph.
2. While keeping both hands on the handlebar (1), move the machine and start scrubbing/drying the fl oor.
3. If necessary, adjust the solution quantity by using the switch (37).
4. When necessary, to use the squeegee in the opposite direction, pry on the handlebar (1) and slightly lift the deck while the
brush is turning. When the deck is turned by 180° start to scrub/dry by drawing the machine.
To resume working in the normal forward direction, push the machine forward until the deck returns to the original position.
WARNING!
Pay attention when lifting the deck with the brush turning: The deck will suddenly turn by 180°. Pay attention to
the moving part, do not hit and/or damage things, walls or people.
CAUTION!
To avoid damaging the fl oor surface, do not use the brush without the solution and, when the machine is not
operating, stop the brush/pad-holder by releasing the levers (40).
CAUTION!
Before lifting the brush/pad, turn it off by releasing the levers (40).
NOTE
For correct scrubbing/drying of fl oors at the sides of the walls, Advance suggests to go near the walls with the right side
of the machine as shown in fi gure 2.
Machine speed adjustment
5. The machine speed varies according to the type of fl oor to be cleaned and the choice of using the brush or the pad. If
necessary, it is possible to adjust the machine speed, according to the procedure shown in Maintenance chapter.
Battery discharge during operation
6. Until the green warning light (38) stays on, the batteries allow the machine to work normally. When the green warning light
turns off and the yellow and red warning lights turn on in sequence, it is necessary to charge the battery as the machine
residual autonomy is at the minimum level.
CAUTION!
Do not use the machine with discharged battery, to avoid damaging the battery and reducing the battery life.
12
INSTRUCTIONS FOR USE
A
9099122000(1)2011-01
Figure 2
SC350
B
P1004108