Large Back; Back - Sauder Hutch 417587 Mode D'emploi

Step 11
Carefully turn your unit over onto its front edges. Unfold
å
the LARGE BACK (H) and lay the BACKS (H and I) over
your unit. Align notches in BACKS (I) to notches in
LARGE BACK (H).
Make equal margins along all edges of the BACKS (H
å
and I). Push on opposite corners of your unit if needed to
make it "square".
Fasten the BACKS (H and I) to your unit using the NAILS (1N)
å
and six BROWN 7/16" LARGE HEAD SCREWS (6S) through
the BACK (H) and into the SMALL BACKS (J).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
BROWN 7/16" LARGE HEAD SCREW
(6 used in this step)
www.sauder.com/services
I
J
6S
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(46 used in this step)
H
J
417587
1N
NAIL
I
Page 15