Sauder Hutch 417587 Mode D'emploi page 21

Step 17
NOTE: You may need someone's help in this step.
å
Remove KEYBOARD SHELF and DRAWERS from the 417586 Corner Computer Desk.
å
Loosen four Hidden Cams in the END and UPRIGHT that attach the RETURN TOP. Remove the BLACK 9/16" LARGE
å
HEAD SCREW above the MODESTY PANEL.
Remove the RETURN TOP and fasten it to your HUTCH. Use two BLACK 1- 7/8" FLAT HEAD SCREWS (2S). into the
å
pre-drilled starter holes in the RETURN TOP. There are two pre-drilled starter holes under the desk top for attaching the
other end of the Hutch. Use a little extra force to start the screws.
Carefully, set the Hutch back onto the base unit. Tighten four HIDDEN CAMS.
å
Fasten the LARGE BACK (H) to the back edge of the RETURN TOP with six BROWN 7/16" LARGE HEAD SCREWS (6S).
å
NOTE: There are no pre-drilled holes in the back edge of the RETURN TOP. Use a little extra force to start the screws.
å
www.sauder.com/services
2S
BLACK 1-7/8" FLAT HEAD SCREW
(4 used for the Desk and Return Top)
Remove this screw.
Loosen these
HIDDEN CAMS.
417587
OPTION 2
BROWN 7/16" LARGE HEAD SCREW
(6 used for the LARGE BACK)
6S
Page 21