Ff Silver 3/4" Machine Screw; Hh Brown 7/16" Large Head Screw - Sauder Utility Stand 409944 Instructions D'assemblage

Step 12
Fasten a FILE BRACKET (57G) to the DRAWER FRONT (J2) as shown in the upper diagram below. Use two
å
BROWN 7/16" LARGE HEAD SCREWS (HH).
Fasten a FILE BRACKET (12B) to the DRAWER BACK (D61). Use two BROWN 7/16" LARGE HEAD SCREWS (HH).
å
Fasten two PULLS (Z) to the DRAWER FRONT (J2). Use four SILVER 3/4" MACHINE SCREWS (FF).
å
Press one of the FILE GLIDES (4B) over the RIGHT DRAWER SIDE (D14) as shown in the lower diagram below. The
å
FILE GLIDES are necessary to hang fi les.
Slide the FILE RODS (CC) through the holes in the FILE BRACKETS (57G and 12B) and into the FILE GLIDE (4B) on
å
the RIGHT DRAWER SIDE (D14).
Slide another FILE GLIDE (4B) onto the other end of the FILE RODS (CC), then press this FILE GLIDE over the
å
LEFT DRAWER SIDE (D15).
SILVER 3/4" MACHINE SCREW
(4 used for the PULLS)
4B
CC
57G
www.sauder.com/services
FF
CC
D15
57G
J2
Z
12B
4B
D14
409944
12B
D61
BROWN 7/16" LARGE HEAD SCREW
(4 used for the FILE BRACKETS)
HH
Page 17