Sauder Hutch 417587 Mode D'emploi page 17

Step 13
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw is against
å
the stops as shown in the right diagram. If it isn't, loosen the mounting screw to
slide it against the stops. Then tighten the mounting screw.
Fasten the DOOR (K) to the LEFT END (B) as shown in the lower diagram. Use
å
the screws in the HINGES. You should start each SCREW a few turns before
completely tightening any of them.
Fasten a KNOB (5K) to the DOOR (K). Use a GOLD 1" MACHINE SCREW (50S).
å
Peel the FELT DISCS from the FELT DISC CARD (1M). Stick two FELT DISCS
å
on the DOOR where it comes in contact with the LEFT UPRIGHT (D).
Repeat this step for the other DOOR (K).
å
See the next step for DOOR adjustments.
å
1M
5K
1M
www.sauder.com/services
B
K
GOLD 1" MACHINE SCREW
(2 used in this step)
D
50S
417587
Stop
Mounting
screw
Hinge
Page 17