Led Indication; Dip-Switch Settings - RISCO Group ProSound Guide D'installation Et De Programmation

LED Indication

LED Description
LED1: POWER
The power LED indicates the sounder operation
On: 13.8VDC is applied to the sounder.
Off: No power supply to the sounder.
Flash: Indicates a trouble in the sounder.
LED2
Status LED indication. (Stand-alone mode)
On: The LED terminal block input is connected to COM (0V).
Off: No connection to the LED terminal input.
NOTE:
In BUS configuration, the LED operation will be defined from the ProSYS control panel

DIP-switch Settings

Stand-Alone Mode
DIP1 Description
SW1 - STROB
Defines the strobe operation mode.
(Default:
On (SA - Automatic): The strobe will follow the sounder activation (C+/-)
ST Trigger)
Off (SM – Manual): The strobe will follow the triggering of the STB input
SW2
Defines the duration time of the sounder activation (Stand Alone mode only).
(Default:
On (T5) : Bell Time 5 min
3 minutes)
Off (T3) : Bell Time 3 min
SW3
Select the triggering command that will activate the sounder.
(Default:
On: C+ Mode:
Default: C-)
Terminal C+/- to positive; , sounder is silent.
Terminal C+/-
.Off: C- Mode:
Terminal C+/-
Terminal C+/-
SW4
Defines the operation mode of the sounder.
(Default:
On (BUS): BUS mode configuration. Use this option for connection to the RISCO
Stand Alone)
BUS.
Off (SA): Stand Alone configuration. Use this option for connection to any panel.
SW5
Defines the siren sweep sound
(Default: Fast)
On (SLO): Slow
Off (FST) : Fast
DIP2 Description
SW1
Defines the triggering of the TRBL output as follows:
(Default:
On (ANY): Follow any trouble in the sounder (low battery, input voltage, speaker
Battery Trouble)
fault)
Off (BAT): Follow battery troubles only (Low voltage or fail in battery load test)
SW2
Sounder's sound
(Default: Standard)
On (FR): Sound is adjusted to French standard NFA2P
Off (ST): Standard sound
open, sounder is activated
to negative; , sounder is silent.
open, sounder is activated
.
5