Operating Tips; Year Warranty - Stanley S50 Guide D'installation Et D'utilisation

All manuals and user guides at all-guides.com
Fig. 3-4 - Repeat the above steps from the other side of the stud. Coming
from the opposite direction, mark the other edge of the stud. The midpoint of
the two marks indicates the stud center.
Cautions on Operating
The proximity of electrical wiring or pipes to the surface of the wall may cause
the stud sensor to detect them as studs. You should always use caution when
nailing, cutting or drilling in walls, ceilings and floors that may contain these
items. Always remember that studs or joists are normally spaced 16 inches
or 24 inches apart and are 1-1/2 inches in width. To avoid surprises be aware
that anything closer together or of a different width may not be a stud.

OPERATING TIPS

Prevent Interference
To ensure best performance from the stud sensor, keep your free hand at
least 6 inches away from the unit and wall surface while testing or scanning
surfaces.
Conventional Construction
Doors and windows are commonly constructed with additional studs and
headers for added stability. The stud sensor detects the edge of these double
studs and solid headers as a single, wide stud.
Surface Differences
Wallpaper – There will be no difference in the function of the stud sensor on
surfaces covered with wallpaper or fabric unless the coverings used contain
metallic foil or fibers.
Ceilings – When dealing with a rough surface such as a sprayed ceiling,
utilize a piece of cardboard when scanning the surface. Run through the
calibration technique described earlier with the piece of cardboard too, to
assure best performance of the unit. Also, it is particularly important in this
application to remember to keep your free hand away from the unit.
Specifications:
Depth Range-
Accuracy- Scanning and marking the stud from two sides
Stud center
(At 35-55% relative humidity)
Shock Resistance:
Water Resistance:
Operating Temperature:
Storage Temperature:

1-YEAR WARRANTY

Stanley warrants its electronic measuring tools against deficiencies in
materials and / or workmanship for one year from date of purchase.
Deficient products will be repaired or replaced, at Stanley's option, if sent
together with proof of purchase to:
Stanley Black & Decker
210 Bath Road
Slough, Berkshire SL1 3YD
UK
Up to ¾" (19 mm) through drywall
±1/8" (3 mm) for wood
±1/4" (6 mm) for metal
Up to 3 feet (1 m) dropped onto
concrete
Water resistant, but not waterproof
+20°F to +120°F (-7°C to +49°C)
-20°F to +150°F (-29°C to +66°C)
GB
3