Stanley S50 Guide D'installation Et D'utilisation page 2

All manuals and user guides at all-guides.com
GB
User Manual
Power LED
Activation Button
STANLEY Stud Sensor 50
®
The stud sensor uses electronic signals to locate the edges of studs or joists
through drywall and plywood up to 3/4". Once the edge of a stud has been
detected, the stud sensor displays a red LED. A pencil notch allows you to
easily note the stud edges on the wall.
WARNING:
Protect Your Eyes, Wear Safety Goggles.
OPERATING INSTRUCTIONS
Battery:
Open door on back of unit and connect a 9-volt battery to
clip. Put battery back into case and close back battery door.
Usage:
Fig. 1 - Hold the stud sensor flat against the surface, making
firm contact.
• Press in and hold the activation button. The green and
red LED's will light. When the red LED goes off, the unit is
calibrated. Keep holding the activation button during all of
the following procedures.
Note: While calibrating, the stud sensor must not be placed
directly over a stud, dense material such as metal, or over
a wet or newly painted area, or it will not properly calibrate.
If the Red LED stays lit, move toa different location and try
again.
Fig. 2 - Slide the stud sensor slowly across the surface in
a straight line. As it detects a stud edge, the red LED will
go on.
• Use the handy pencil notch located at the top of the unit to
mark the stud edge.
2
Marking Notch
Edge Detection LED
Figure 1
Figure 2
Figure 3
Figure 4