Monitoring The Sound Signal, Headphone Connection - Sennheiser EM 3031-U Notice D'emploi

16

Monitoring the sound signal, headphone connection

Socket on the EM 3031/3032 receiver can be used to monitor the sound signal received with
headphones. The headphone volume is adjusted with control
Please use headphones with a
The Sennheiser HD 25 headphone is especially usefull for this purpose.
In order to judge the quality of the received sound signal even under unfavourable conditions (low
AF level in the transmitter) and with high ambient noise (e.g. on the stage), the sound signal at
socket can be monitored at an amplification of up to 30 dB compared with the LINE output.
For strong sound signals, however, this can distort the sound if control
In this case, turn control
transmitter itself is overmodulated.
Volume up? – No!
First of all, the volume control
(by turning it anti-clockwise as far as possible). Then turn up the volume control
gradually until you have reached the desired volume.
When people use headphones, they tend to choose a higher volume than with
loudspeakers. Listening at high volume levels for long periods can lead to permanent
hearing defects. Please protect your hearing, and as far as possible, check the sound
signal only briefly with the headphone.
44
All manuals and user guides at all-guides.com
1 / " (6.3 mm) ø stereo jack plug. The sound signal itself is mono.
4
down until the distortion disappears. If the distortion remains, the
should always be adjusted to the lowest volume
.
is turned to a high level.