ABB ACQ580-34 Guide D'installation Rapide page 16

16 EN – Quick installation guide
Notes:
1. Current [0(4)...20 mA, R
of setting requires changing the corresponding parameter.
2. Total load capacity of the Auxiliary voltage output +24V (X2:10) is 6.0 W (250 mA / 24
V) minus the power taken by the option modules installed on the board.
3. In scalar control: See Menu > Primary settings > Start, stop, reference > Constant
speeds / constant frequencies or parameter group 28 Frequency reference chain.
In vector control: See Menu > Primary settings > Start, stop, reference > Constant
speeds / constant frequencies or parameter group 22 Speed reference selection.
4. Connected with jumpers at the factory.
5. Use shielded twisted-pair cables for digital signals.
EN
6. Ground the outer shield of the cables 360 degrees at the cabinet entry.
DA WARNING! Connect external AC power supply (24 V AC) to control unit
connectors 40 and 41. If you connect it to connector AGND, DGND or SGND, the
power supply or the control unit can get damaged.
DE
Remove the cardboard covers
ES
After the electrical installation has been done and there is no danger of dropping screws or
anything else inside the drive or LCL filter module, remove the cardboard covers from the
FI
top of them.
FR
IT
NL
PL
PT
RU
SV
TR
ZH
All manuals and user guides at all-guides.com
= 100 ohm] or voltage [0(2)...10 V, R
in
>200 kohm]. Change
in