Table des Matières
Publicité
Step 20
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the RIGHT DOOR (U) to the INNER RIGHT
å
END (C). Use the screws in the HINGES.
Peel a FELT DISC from the FELT DISC CARD (TT) and
å
stick it on the DOOR where it comes in contact with the
RIGHT UPRIGHT (E).
Fasten a KNOB (PP) to the RIGHT DOOR (U). Use a
å
BLACK 1-1/8" MACHINE SCREW (WW).
Repeat this step for the LEFT DOOR (V).
å
www.sauder.com/services
E
For support, place packing
foam and magazines here.
412308
Stop
Mounting
screw
Hinge
TT
C
U
TT
BLACK 1-1/8" MACHINE SCREW
(2 used for the KNOBS)
PP
WW
Page 25
Publicité
Table des Matières
