Table des Matières
Publicité
Step 18
Carefully turn your unit over onto its front edges. Lay the
å
BACK (L) over your unit.
Make equal margins along all four edges of the BACK (L).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (L) to your unit using the NAILS (BBB).
å
Next, fasten the LOWER BACK (K) to your unit using the
å
NAILS (BBB). The LOWER BACK will overlap the BACK.
NOTE: Be sure to tap NAILS into the holes that line up
å
over the UPRIGHTS (E and F).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
Do not tap NAILS into the
holes along this edge.
www.sauder.com/services
K
NOTE: The BACK hangs
past the bottom of the unit.
(55 used in this step)
These holes must line up over
the UPRIGHTS (E and F).
412308
BBB
NAIL
L
Page 23
Publicité
Table des Matières
