Sauder Hutch Mode D'emploi page 18

Step 13
Insert a PIVOT HINGE (II) into the TIE PLATE on the LONG SHELF (I).
å
Insert the PIVOT HINGE, which is fastened to the SMALL DOOR (M),
å
into both WASHERS (LL), and into the hole in the MOUNTING
PLATE (P). You will need to tilt your DOOR slightly.
Now, tip the SMALL DOOR in and fasten the free HINGE to the SMALL
å
DOOR. Use a BLACK 9/16" LARGE HEAD SCREW (ZZ).
NOTE: To make adjustments to the DOOR, loosen the SCREW in the
å
HINGE, make needed adjustments, and tighten the SCREW.
Push a MAGNETIC CATCH (JJ) into the hole in the
å
MOUNTING PLATE (P).
JJ
Page 18
P
M
412308
LL
BLACK 9/16" LARGE HEAD SCREW
(1 used in this step)
II
I
ZZ
www.sauder.com/services