Safety Information; Safety Advices - SEFRAM SEFRAM70 Manuel D'utilisation

Understand and follow operating instructions carefully.
• If the equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may
be impaired.
• Always use proper terminals, switch position, and range for
measurements.
• To reduce the risk of fire or electric shock, do not use this
product around explosive gas or in damp locations.
• Verify the Meter operation by measuring a known voltage.
If in doubt, have the Meter serviced.
• Do not apply more than the rated voltage, as marked on
Meter, between terminals or between any terminal and earth
ground.
• Avoid working alone so assistance can be rendered.
• Do not use the Tester if the Tester is not operating properly
or if it is wet.
• Individual protective device must be used if hazardous live
parts in the installation where the measurement is to be carried
out could be accessible.
• Use caution with voltages above 30 Vac rms, 42 Vac peak, or
60 Vdc. These voltages pose a shock hazard.
• DO NOT USE the test leads when the internal white insula-
tion layer is exposed.
• DO NOT USE the test leads above maximum ratings of CAT.
environment, voltage and current, that are indicated on the
probe and the probe tip guard cap.
• DO NOT USE the test leads without the probe tip guard cap
in CAT III and CAT IV environments.
• Probe assemblies to be used for MAINS measurements shall
be RATED as appropriate for MEASUREMENT CATEGORY
III or IV according to IEC 61010-031 and shall have a voltage
RATING of at least the voltage of the circuit to be measured.
• Disconnect circuit power and discharge all high-voltage
capacitors before testing resistance, continuity.

SAFETY ADVICES

Depending on the internal impedance of this meter there will be a
different capability of indicating the presence or absence of operating

Read First
 Safety Information
 WARNING