Parkside PKLL 8 A1 Traduction Des Instructions D'origine page 25

Remove exhausted batteries / rechargeable batteries from the
product immediately.
Initial use
Check that the delivery is complete and that there is no visible
damage.
Remove the packaging material from the product.
Inserting / Changing batteries
Open the battery compartment .
5
Insert the batteries. Ensure that batteries are inserted correctly
(polarity) according to the picture on the inside of the battery
compartment.
Close the battery compartment .
5
Note: when the battery is low, the LED indicator
blinks red.
2
Always replace all batteries at the same time. Only use batteries
from the same manufacturer and with the same capacity.
Remove the batteries from the product if it will not be in use for a
prolonged period of time. In long periods of storage the batteries
can corrode and can run themselves down.
Switching on/off
To switch the product on, push the LOCK switch to the
3
position . Immediately after being switched on, the product
releases two laser lines from the laser beam opening .
7
26 GB/IE