Cebora Power Rod 200 M Manuel D'instructions page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
required accessories are connected to the adapter H (Art.
513). This machine is intended for use with the following
accessories:
a) torch type T 150 Art. 1567-20 with gas valve and start
trigger
b) torch type T 150 Art. 1567-02 with gas valve, start
trigger and current setting potentiometer
c) Art. 181 pedal with potentiometer for current adjustment
d) Art. 1180 adapter to simultaneously attach the torch
Art.1567-20 or 1567-02 and the pedal Art. 181.
e) torch Art. 1567.01 (Art. 506).
4 MAINTEINANCE
Any maintenance operation must be carried out by
qualified personnel in compliance with standard CEI 26-
29 (IEC 60974-4).
4.1 POWER SOURCE MAINTENANCE
n the case of maintenance inside the machine, make sure
that the switch F is in position "O" and that the power
cord is disconnected from the mains.
It is also necessary to periodically clean the interior of
the machine from the accumulated metal dust, using
compressed air.
4.2 PRECAUTIONS AFTER REPAIRS.
After making repairs, take care to organize the wiring so
that there is secure insulation between the primary and
secondary sides of the machine. Do not allow the wires
to come into contact with moving parts or those that heat
up during operation. Reassemble all clamps as they were
on the original machine, to prevent a connection from
occurring between the primary and secondary circuits
should a wire accidentally break or be disconnected.
Also mount the screws with geared washers as on the
original machine.
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Power rod 180 m506513

Table des Matières