Site Preparation; Opening Dimensions; Dual Installation - Sub-Zero Designer Serie Guide D'installation

Site Preparation

Opening Dimensions

DESIGNER SERIES UNDERCOUNTER MODELS
24"
OPENING
H
OPENING
HEIGHT
SIDE VIEW
1
NOTE: 3 / " finished returns will be visible and should be finished to match cabinetry.
(89)
2
3
/ "
4 (19)
TYPICAL
1
3 / "
2 (89)
FINISHED
RETURN
W
FRAMELESS
CABINETRY
OPENING DIMENSIONS
24" Model
4 | Sub-Zero Customer Care 800.222.7820
(610)
DEPTH
TOP VIEW
W
OPENING WIDTH
FRONT VIEW
3
/ "
4 (19)
TYPICAL
1
3 / "
2 (89)
FILLER
FINISHED
RETURN
W
FRAMED
CABINETRY
W
24" 34 1/2"
(610)
The depth of each model is 23 1/8"
thickness when planning the finished opening depth. A
minimum 3 1/2"
(89)
the opening. Framed cabinets require additional finished
filler material behind the face frame for a proper installa-
tion. Refer to the illustration.

DUAL INSTALLATION

If two units are installed side by side, a dual installation kit
may be required. Installations without a custom filler strip
require a dual installation kit. If a dual installation kit is not
specified, a 2"
(51)
units. Dual installations without a filler strip can only be
accomplished using two units with opposite hinges. Refer
to the illustrations below.
Dual installation kits are available through an authorized
Sub-Zero dealer. For local dealer information, visit the find
a showroom section of our website, subzero.com. For
questions regarding the installation, call Sub-Zero Cus-
tomer Care at 800-222-7820.
DUAL OPENING WIDTH
Two 24" Models
Dual installation kit required.
H
(876)
WITHOUT FILLER STRIP
Opposite hinges
. Allow for panel
(587)
finished return is required on all sides of
filler strip is recommended between the
FILLER STRIP
Same side hinges
W
48"
(1219)