Initial Use - Princess Party 8 Stone Raclette & Grill Set Mode D'emploi

• Do not move the appliance while it is
switched on or is still hot. Remove the
mains plug from the wall socket and wait
until the appliance has cooled down.
• Do not use the appliance near birds
(e.g. tropical birds such as parrots). The
grill plate is finished with a non-stick coating
based on PTFE. Upon heating, the coating
may release small amounts of gases which
are fully harmless for people. However,
the nervous systems of birds are extremely
sensitive to these gases.
U.K. Wiring instructions
The wires in the mains lead are coloured in
accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
GREEN/YELLOW EARTH
As the colours of the wire in the mains lead of
this appliance may not correspond with the
colour markings identifying the terminals on
your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter L or coloured red.
The wire which is coloured GREEN/YELLOW
must be connected to the terminal which is
marked with the letter E or (
GREEN or GREEN/YELLOW.
If a 13Amp (BS1363) plug is used, a 13Amp
(BS1362) fuse must be fitted, or if any other
type of plug is used, a 13Amp fuse must be
fitted, either in the plug or adaptor, or on the
distribution board.
Warning! This appliance must be earthed.
Description (fig. A)
Your 162352 Princess grill and raclette set has
been designed for grilling and racletting.
The appliance is suitable for indoor use only.
1. On/off switch
2. On/off indicator
3. Grill plate
4. Grill stone
5. Bottom plate
6. Pan
7. Spatula

Initial use

Warning!
- Make sure that there is sufficient space
around the appliance to allow heat to
escape and provide sufficient ventilation.
• Clean the appliance. Refer to the section
"Cleaning and maintenance".
• Clean the accessories. Refer to the section
"Cleaning and maintenance".
• Place the appliance on a stable and flat
surface.
• Insert the mains plug into the wall socket.
• Switch on the appliance with a high
temperature.
• Allow the appliance to cool down completely.
Note: If you switch on the appliance for the
first time, the appliance may emit a little smoke
and a characteristic smell for a short period.
This is normal operation.
Assembly
Warning!
- Before assembly, always remove the
) and is coloured
mains plug from the wall socket.
Mounting the grill plate (fig. B1)
The appliance is equipped with a grill plate
with a non-stick coating.
• Place the appliance on a stable and flat
surface.
• Place the grill plate (3) onto the pins (8).
Make sure that the pins (8) are inserted
into the holes (9) in the grill plate (3).
• Lock the grill plate (3) by pushing it to the
left or to the right as far as possible.
Mounting the grill stone (fig. B2)
The appliance is equipped with a grill stone.
• Place the appliance on a stable and flat
surface.
11