Robam CXW-260-A671 Mode D'emploi page 46

Filer disassembly
1. Long press the cleaning button to open the air deflector.
2. Hold the two magnetic clasps on the filter with both hands
,
be absorbed then lift the filter according to the direction of the arrow to make it separated from the neck
pull out the filter to clean the filter
Hood disassembly
1. Take down the lamp according to the lamp disassembly steps;
2.Take down the switch assembly according to the switch disassembly steps;
3.Take down the filter according to the filter disassembly steps;
4.Unscrews the screw on the back plate, remove the back plate, unscrew the screws on the air duct outlet, remove the
air duct and unscrew the 6 screws on the check ring;
5.Unscrew the cap clockwise and take out the impeller vertically;
The assembly steps are opposite to the disassembly steps.
(When installing the impeller, please apply some lubricating oil in the axle hole of the impeller.)
Back plate
Duct
Range Hood
.
Check ring
Motor Impeller
Cap
,
slightly exert force outwards to make the filter no longer
Neck Magnetic clasp
The body may not be disassembled under
normal circumstances.
The disassembly work should be completed
by professional maintenance personnel.
Mainframe
Oil cup
44
,
and finally
Filter Air deflector