Removal Of Components - Robam CXW-260-A671 Mode D'emploi

1. As a general rule, the hood body does not need to remove, and removal shall be done by professional maintainers.
Nonprofessionals are forbidden to remove, install and repair the hood.
2. Before cleaning, installation or maintenance for the range hood, cut off the power supply to avoid electric shock.
Note: The installation procedures of the following components are in reverse with the removal. Please wear protective
gloves during operation to prevent the sharp edge of metal hurting your hands.
Lamp removal
1. Long press the cleaning button to open the air deflector, unplug the power, use a cross screwdriver to unscrew the two
screws on the cover plate and take out the cover plate according to the direction of the arrow;
2.Push out the lamp from the inside by hand and unplug the connecting wire for repair and replacement.
2- / 1
8
Switch removal
1. Long press the cleaning button to open the air deflector, unplug the power, use a cross screwdriver to unscrew the
two screws on the cover plate and take out the cover plate according to the direction of the arrow;
2. Pull out the switch assembly and unplug the connecting wire for repair and replacement.

Removal of Components

Lamp image
"(54 mm)
Warning
Cover plate
Lamp Type
Max Power
Voltage
1 / "(7 mm)
Size
4
Cover plate
Switch assembly
43
Range Hood
Lamp
Lamp information
Rectangular LED
2W
12VDC
See the lamp image