Robam CXW-260-A671 Mode D'emploi page 36

6. Paste the opening sample plate with the text surface downwards on the bottom plate of the upper cabinet, and use
the electric saw and the drill bit of diameter
sample plate.
Note: wear the goggles and gloves when opening the holes.
7. Lift up the range hood and hang the hanging foot on the bottom hanging hole, then push the range hood to the wall,
so that the back of the range hood is close to the wall.
8. Fix the range hood with four M5×40 screws from the bottom plate of the upper cabinet and fix with at least two screws
before freeing it from the hand.
9. If there is a large gap between the cabinet bottom plate and the range hood, please add cushion block according to
gap size near four M5×40 screws before installation, so as not to make the range hood enclosure deform and affect use
when fastening the screws.
Note: two or more persons are required to install this range hood for safety.
Range Hood
1 / " (7mm) to open holes according to the requirements on the opening
4
M5×40 screw
Gasket
Upper cabinet
bottom plate
Range
hood
Block
34
M5×40 screw
Gasket
Upper cabinet
bottom plate
Range
hood