Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.
1.Determine the installation position of the hitching leg and the hitching leg fixed block: confirm the hitching leg position with
the inside of the upper cabinet plate bottom as the base and mark the drill holes. The relevant size is given as below:
1)When using the 6" decoration panel, the distance from the inside of the upper cabinet panel bottom to the top of the
hanging leg is 4- "(115mm) ;
1
/
2
2)When using the 12" decoration panel, the distance from the inside of the upper cabinet panel bottom to the top of the
hanging leg is 10- "(267mm) ;
1
/
2
3)The installment pitch of holes between the center of the hitching leg hole and the hitching leg stop block is 2- "(60±2mm).
15- /
1
"(395mm)
2
B area
2"
(50mm)
A area
2- /
3
"
8
(60mm)
5.
Drill a hole 2- "(60mm)-2- "(70mm) deep (not too large) at the mark with a drill bit with a diameter of
3
/
8
press the expansion pipe into the hole. Drill a hole with a diameter of
(50mm)-2-
3
/
"(55mm) at the fixing hole mark of the hitching leg stop block, and insert the M6 metal expansion pipe
16
into the hole.
6. Remove M6 metal expansion pipe, nut and washer,
supplied with the machine. Use a level ruler to make sure the hitching leg is in a horizontal position.
Note: The hitching leg must be fixed to the beam with a screw.
7. Paste the opening sample plate with the text surface downwards on the bottom plate of the upper cabinet, and use the
electric saw to open holes according to the requirements on the opening sample plate.
Note: wear the goggles and gloves when opening the holes.
Range Hood
Hitching leg
stop block
mounting hole
3
2- /
"
8
(60mm)
4×60
wood screw
3
/
4
Metal
expansion pipe
3
/
" (10
mm
8
Plastic
expansion pipe
and reliably fix the hitching leg with 4× 60mm wood screws
36
3
/
8
Plane fixing
the decoration
panel inside
the bottom
of the upper
1
4- /
"(115mm)
or
2
cabinet plate
10- /
1
"(267mm)
2
B
as the base
A
) (
not too large and a depth of
)
5
/
"(8mm),
16
2"
Publicité
Table des Matières
