Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Mainframe panel
Attached panel of the mainframe
Hitching leg stop block
2.5",6"or12"decoration panel
Hitching leg stop block
1.The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels,
the discharge of air must fulfill the requirements of local regulations.
2.Note that when installing the metal expansion pipe, the pipe shall match with the hole in size. Overlarge hole is
prohibited, as it will result in loose pipe and accidental drops.
3.There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas
or other fuels.
4.If the flue aperture is less than air duct aperture, it will influence the fume suction effect and the too long air duct will
influence the fume suction effect, too.
5.This appliance just for household use only.And it's not allowed to exhaust dangerous or explosive matter or air. It should
be put under dry and ventilation environment without dangerous air.
Preparation for installation
●Surrounding
Keep the hood away from too many doors and windows, so as to avoid air convection affecting the efficiency.
●Tools preparation
The hood will be installed with the following tools
Mainframe panel accessories (optional)
1
M4×8 pan head screw assembly
1
ST4.2× 8
1
Decoration panel accessories (optional)
1
ST4.2× 8
1
Installation
Warning
31
M4 nut
Ø gasket
4
1
self tapping screw
M6
metal expansion pipe
1
self tapping screw
M6
metal expansion pipe
Range Hood
2
2
2
4
1
4
1
Publicité
Table des Matières
