Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.
Drill a hole 2- "(60mm)-2- "(70mm) deep (not too large) at the mark with a drill bit with a diameter of
3
/
8
press the expansion pipe into the hole. Drill a hole with a diameter of
(50mm)-2-
3
/
"(55mm) at the fixing hole mark of the hitching leg stop block, and insert the M6 metal expansion pipe
16
into the hole.
6. Remove M6 metal expansion pipe, nut and washer,
supplied with the machine. Use a level ruler to make sure the hitching leg is in a horizontal position.
Note: The hitching leg must be fixed to the beam with a screw.
7. Put the sealing gasket at the air outlet of the range hood, and fix the check valve with eight ST4.2x18 screws.
8. Lift the range hood, hang the back hook at the hitching leg and use a level ruler to ensure that the machine is horizontal.
Check valve
ST4.2×18 screw
Check valve seal
3
/
4
Metal
expansion pipe
3
/
" (10
mm
8
Plastic
expansion pipe
and reliably fix the hitching leg with 4× 60mm wood screws
39
Range Hood
5
) (
not too large and a depth of
)
/
"(8mm),
16
2"
Publicité
Table des Matières
