John Bean EHP System II-E Manuel D'utilisation page 16

SRA
1
2
16
- EN
I
H
4.1-2
4.1-3
4.1-4
When SRA is fi tted.
H.
Safety Restraint Arm swings to center of the turntable
•
(Fig. 4.1-2).
I.
Lift upward on the restraint positioning knob to position
•
over tire/wheel assembly for infl ation, at the same
time push down on the Anti-rotation Lock Arm to
release lock. You may now swing the safety restraint
arm to position on the center of the wheel. Lower the
restraint until the rubber pad on the restraint disc is
resting on the rim center. The SRA is a gravity lock
which will automatically lock if any force other than
the restraint position knob is lifted. You are now ready
for the infl ation process.
NOTE: the air supply will not function until the safety
arm is centered over the turntable.
Only for Tubeless wheel models:
F1. Press bead seater/infl ator pedal (1, Fig. 4.1-3) on
left side of the machine half way down: air will come from
infl ation hose end only (2, Fig. 4.1-3).
F2. Press bead-seater pedal (1, Fig.4.1-3) down swiftly
to get air blast from the turntable jets (3, Fig.4.1-3).
Note: Air simultaneously continues to exit the hose (2,
Fig. 4.1-3) connected to the tire.
WA R N I N G : O N C E B E A D I N G I S C O M P L E T E ,
IMMEDIATELY STOP INTRODUCING AIR.
3
(Fig. 4.1-4)
WHEN OPERATING THE BEADING DEVICE IT IS
MANDATORY TO WEAR EAR PROTECTORS AND
SAFETY GLASSES TO PREVENT CONTAMINATION
FROM NOISE, DUST AND CHIPS BLOWN BY THE AIR
JETS.
DANGER OF TIRE EXPLOSION