Operations
Returning to the home position
(HOME button)
Press the HOME button on the operation panel or on
the remote commander. The camera angle and zoom
revert to the preset angle and focus becomes
automatic. The HOME button is for both document
and flip-up positions.
SET
HOME
Changing the home position setting
You can change the camera angle and zoom for the
position you want to set. While pressing the SET
button on the operation panel, press the HOME button
for 5 seconds. When the setting is finished, a beep
sounds. Only camera angle and zoom can be set by the
HOME button. The home position setting is retained
even when you turn off the POWER.
Notes
• The home position (camera angle and zoom) is the
same for both document and flip-up position. When
you change the home position setting in the document
position, the home position setting in the flip-up
position is also changed.
• You can not change the home position setting on the
remote commander.
Adjusting the focus manually
(FOCUS buttons)
Use the FOCUS buttons on the operation panel to
adjust the focus. You can also adjust the focus for a
three-dimensional object by using the NEAR and FAR
buttons. Adjust the focus manually when you display:
• a material that includes small type or fine patterns
which are difficult to focus,
• a material of low contrast, or
• a three-dimensional object.
You can lock the focus when the focus is adjusted
automatically. Press the FAR or NEAR button once to
lock the focus.
20
If you move the camera angle while the focus is
locked, it will become out of focus. In this situation,
set the focus to automatic.
HOME button
T
W
To go back to automatic focus
Press the AUTO button to light the AUTO indicator.
Adjusting the iris (Brightness) manually
(IRIS buttons)
Use the IRIS buttons on the operation panel to adjust
the iris (brightness). To increase the brightness, press
the OPEN button. To decrease the brightness, press the
CLOSE button. Adjust the iris manually when you
want to display:
• an object which reflects light strongly and the picture
looks whitish,
• a pale-colored film negative, or
• the contrast strongly.
To go back to automatic iris
Press the AUTO button to light the AUTO indicator.
FOCUS
AUTO
NEAR
FAR
IRIS
AUTO
CLOSE
OPEN