Adjusting The Parts; Adjusting The Camera - Sony VID-P150 Mode D'emploi

Preparation

Adjusting the Parts

Adjusting the camera

The VID-P150 allows you to shoot in two positions:
the document position is for shooting material on the
stage, the flip-up position is for shooting material on a
wall by tilting the camera upward through 90 degrees
manually.
Move the cover manually to adjust the camera to the
document position or the flip-up position to meet your
needs.
Document position
Cover
Flip-up position
14
Flip-up position
Document position
Adjusting the arm lights
Adjust the angle of the arm lights depending on the
object.
If the light supporting arms loosen
If the arms will not stay upright, the screw in the base
may be loose. After turning off the POWER switch,
tighten the screw as shown below.
The arm cannot stand upright.
Opening in the base for
adjusting the light
supporting arm
Tighten the screw inside
slightly, but not excessively.
Cross-headed screwdriver