Sony VID-P150 Mode D'emploi page 18

Operations
Switching the lighting (LIGHTING button)
The arm lights turn on automatically when the power
is switched on. Each time you press the LIGHTING
button, the lighting changes as follows.
The arm light turns on.
m
µ
The back light turns on.
µ
All the lights tuns off.
When shooting and displaying transparencies such as
transparent sheets, slides and film positive, press the
LIGHTING button to switch the light from the arm
lights to the back light.
When you press the LIGHTING button repeatedly,
wait 1 second before you press the LIGHTING button
again.
Arm lights
Back light
Selecting the signals to output
(VIDEO OUT buttons)
The VIDEO OUT buttons on the operation panel
allow you to switch the pictures shot with this unit to
those from the connected video equipment and vice
versa.
VIDEO OUT
CAMERA VIDEO 1
18
LIGHTING button
VIDEO 2
To output the video signal from the VID-P150
camera and the audio signal from the
microphone connected to the MIC connector
Press the CAMERA button. The video signal from the
camera of the VID-P150 and the audio signal from the
microphone connected to the MIC connector are
automatically output.
When turned on, the video signal from the camera is
automatically output.
To output a signal from the video equipment
connected to the VID-P150
Press the VIDEO 1 or VIDEO 2 button.
The VIDEO IN connectors on the rear panel are
interlocked to the VIDEO buttons, the VIDEO IN 1
connector to the VIDEO 1 button and the VIDEO IN 2
connector to the VIDEO 2 button.
When the microphone is connected, this unit outputs
sound by mixing the audio signal from the AUDIO IN
connectors with the audio signal from the microphone.
When you want to switch the video signal from the
input connectors to the camera, press the CAMERA
button.
Note
When you connect video equipment to both the S
VIDEO IN 1 connector and the VIDEO IN 1 connector
on the rear panel, the video signal from the S VIDEO
IN 1 connector is automatically output. It is the same
when you connect both the VIDEO IN 2 and S VIDEO
IN 2 connectors.
Adjusting the microphone level
(VOL control)
Use the VOL control on the front of the VID-P150 to
adjust the level of the microphone connected to the
MIC connector. Turn it to the right to increase the
volume. Turn it to the left to decrease the volume.
MIC
VOL control
Microphone