Controlling The Vid-P150 From A Computer - Sony VID-P150 Mode D'emploi

Operations
Camera angle and remote commander
setting (BIT switch)
The functions of BIT switch (camera angle and remote
commander setting switch) are as follows. Set the
switch to meet your needs.
BIT SWITCH
4 REMOTE COMMANDER
3 REMOTE CONTROL
2 CAMERA DIRECTION b)
1 CAMERA ANGLE
a) All switches are set to ON at the factory.
b) STD (forward) is when the camera moves in the same
direction as the camera angle buttons. REV (backward) is
when it moves in reverse of the camera angle buttons.
The remote commander number
Match the REMOTE COMMANDER number with the
BIT switch on the rear panel and with the REMOTE
COMMANDER number switch on the remote
commander.
To match the REMOTE COMMANDER number
22
ON a) OFF
1 2
ON OFF
STD REV
8-WAY 4-WAY
T
W
Shooting a three-dimensional object
To shoot and display a three-dimensional object, lower
the camera stand. You can also shoot it from one
angle.
Shoot the object
from one angle.
Lower the
camera stand.
Using the accessory shoe for an LCD
monitor
This unit has an accessory shoe for attaching an LCD
monitor.
Controlling the VID-P150 From a
Computer
You can control the VID-P150 from a computer
connected by an RS-232C connector. However, the
software to control the VID-P150 must first be
installed. Refer to the "Interface Manual" for details
on the communication protocol for this software.
Shoot the object
from the top.
Tighten the lock knob.