Adjusting The Parts; Adjusting The Camera; Collapsing The Unit - Sony VID-P110 Mode D'emploi

Adjusting the Parts

Adjusting the camera

When the picture is not upright, rotate the camera up
and down and move it from left to right to adjust.
Adjusting the arm lights
Adjust the angle of the arm lights depending on the
object.
If the light supporting arms loosen
If the arms will not stay upright, the screw in the base
may be loose. After turning off the POWER switch,
tighten the screw as shown below.
The arm cannot stand upright.
Opening in the base for
adjusting the light
supporting arm
Tighten the screw inside
slightly, but not excessively.
Cross-headed screwdriver

Collapsing the Unit

Follow the instructions below to collapse the VID-
P110 for transportation or convenience.
1
Fold both arm lights down onto the base.
2
Rotate the camera parallel to the camera stand.
Carefully fold down the camera stand toward the
operation panel side until it locks.
Camera stand
Cautions
• Lay the unit down flat. Do not try to stand it on its
rear or sides. Doing so may cause the unit to fall
resulting in damage or personal injury.
• Do not try to pick up this unit by the camera stand.
This may cause the unit to malfunction, and may
cause you injury.
NOT this way NOT this way
Arm lights
Camera
Rotate parallel to
the camera stand.
NOT this way
13