FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result caus-
A. This appliance does not have a pilot. It is equipped with
an ignition device which automatically lights the burner.
Do not try to light the burner by hand.
B. BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
1. STOP! Read the safety information above.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition
device which automatically lights the burner. Do not try
to light the burner by hand.
VINYL CAP
GAS CONTROL LEVER SHOWN
IN "OFF" POSITION
CONVERTIBLE
REGULATOR
TOP VIEW
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if
service is to be performed .
3. Remove control access panel (front panel).
19562-4-0610
LIGHTING INSTRUCTIONS
ing property damage, personal injury or loss of life.
OPERATING INSTRUCTIONS
OFF
BACK END VIEW
TO TURN OFF GAS TO APPLIANCE
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in
or turn by hand, don't try to repair it; call a qualified
service technician. Force or attempted repair may result
in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
5. Remove control access panel (front panel).
6. Turn gas control knob clockwise
"OFF."
7. Wait ten (10) minutes
Then smell for gas, including near the floor. If you smell
gas, STOP! Follow "B" in the safety information above.
If you don't smell gas, go to the next step.
8. Tu r n g a s c o n t r o l k n o b c o u n t e r c l o c k w i s e
to "ON".
9. Replace control access panel (front panel).
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the instructions
"TO TURN OFF GAS TO APPLIANCE" and call your
service technician or gas supplier.
4. Turn gas control knob clockwise
"OFF." Do not force.
5. Replace control access panel (front panel).
to
to clear out any gas.
to
Page 13