Kenwood JMP40 Instructions page 7

to assemble your juicer (Aè I)
Aè B
Fit the pulp stopper into the opening on
the underside of the juicing bowl
push in until secure.
C
Fit the juicing bowl
9 by positioning the juice spout to the
front.
D
Place the filter
4
, pushing down to secure into place.
5
E
Place the scroll
3
and push down to secure. Note: the lid
with the (graphic) on the power unit
cannot be fitted if the scroll is not fully
with the (graphic) on the power unit
pushed down.
FèG
(graphic) on the bottom of the bowl
(graphic) on the bottom of the bowl
Fit the lid onto the unit ensuring the
2
lines up with the
unlock graphic
unlock graphic
of the juicing bowl. Then turn the lid
clockwise until it clicks into place and the
lock graphic / Fit the lid onto the unit and click into place (x)
lines up with the
lock graphic / Fit the lid onto the unit and click into place (x)
the juicing bowl.
lter holder assembly into the juicing bowl and align the (graphic)
Hè I
lter holder assembly into the juicing bowl and align the (graphic)
Close the lid lock.
(graphic) on the juicing bowl
(graphic) on the juicing bowl
to use your juicer (J)
Place the pulp container
pulp spout and place the juice jug
6
under the juice spout
drip stopper bn is in the open position
before juicing.
Switch on and feed the food items down
bk
slowly using the pusher.
Use the recommended usage chart as
l
a guide for juicing different fruits and
vegetables.
To extract the maximum amount of juice,
l
always push the food down slowly using the
pusher. Do not use excessive force as the
food should be pulled down by the scroll.
If the food becomes jammed in the feed
l
tube or on the scroll and the juicer stops
operating switch to the '
Then press and hold the '
down until the food becomes dislodged.
Once the food is released, you can start
juicing again.
and
5
5 to the power unit
into the juicing bowl
into the juicing bowl
▲
on the front
▲
on the front of
switch graphic, on, o & reverse
under the
7
switch graphic, on, o & reverse
. Ensure the anti-
bm
with the (graphic) on the power unit
with the (graphic) on the power unit
(graphic) on the bottom of the bowl
(graphic) on the bottom of the bowl
unlock graphic
unlock graphic
lock graphic / Fit the lid onto the unit and click into place (x)
lock graphic / Fit the lid onto the unit and click into place (x)
lter holder assembly into the juicing bowl and align the (graphic)
lter holder assembly into the juicing bowl and align the (graphic)
(graphic) on the juicing bowl
(graphic) on the juicing bowl
' off position.
switch graphic, on, o & reverse
' reverse button
switch graphic, on, o & reverse
hints and tips
Wash all fruit and vegetable thoroughly
l
before juicing.
To maximise juice extraction place small
l
quantities at a time in the feed tube and
push down slowly.
Hard foods are best juiced at room
l
temperature.
You do not have to remove thin peels
l
or skins. Only remove thick peels that
you would not eat e.g. those of oranges,
pineapples, melons and uncooked
beetroots.
Use fresh fruit and vegetables as they
l
contain more juice.
Remove stones and hard seeds from
l
cherries, plums etc.
Vitamins disappear - the sooner you drink
l
your juice, the more vitamins you will get.
If you need to store the juice for a few hours
l
put it in the fridge. It will keep better if you
add a few drops of lemon juice.
Health Recommendations
Do not drink more than three 230mls (8
l
fl.oz.) glasses of juice a day unless you are
used to it.
Dilute juice for children with an equal
l
amount of water.
Juice from dark green (broccoli, spinach
l
etc.) or dark red (beetroot, red cabbage
etc.) vegetables is extremely strong, so
always dilute it.
Fruit juice is high in Fructose (fruit sugar),
l
bo
so people with diabetes or low blood sugar
should avoid drinking too much.
after juicing (K)
After adding the last piece of food, allow
the juicer to run to help clear the juice
from the juicing bowl. The time will vary
depending on the fruit type and thickness
of the juice extracted.
Switch off and wait until the final flow of
juice has reduced to a few slow drips. Then
place the anti-drip stopper
before removing the jug.
Refer to the troubleshooting
section if you experience any
problems with the operation of
the juicer.
4
in position
bn