Wahl 8550 Manuel D'utilisation page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

blades before packing it away (refer to instructions on CARE AND SERVICES).
GROOMING HORSES
When clipping large animals, care should be taken as some animals may be nervous around the noise and vibration of the clipper.
BEFORE YOU CUT
1) Make sure clipper is clean and in perfect working condition. towel dry. Then comb and brush the longer mane and tail.
CUTTING HAIR
1) Start with the front legs. Clipping with the grain (or lay) of the hair will give a slightly longer cut. The leg can be clipped while the hoof is on the ground
or with the leg in your hand. Clip the fetlocks, being careful around joints and projections. Proceed with all four legs.
2) Clip the hair around the muzzle, chin and ears. All the hair on the outside of the ears can be clipped, but avoid clipping the hair on the inside. Be care-
ful, also, when clipping the hair on the edges of the ears; do not hold the clipper with the blades pointing toward the edges, but parallel to the edges.
3) If you wish to shorten the hair on the mane and tail, hold the hair between your index and middle fingers with the amount of hair you wish to cut pro-
truding above your fingers. Then cut that hair off with a parallel stroke across fingers.
4) To thin the hair on the tail and mane, hold your clipper upside down with the blades pointed in toward the hair. Then, starting at the top of the hair and
lightly stroking downward in a combing-like manner, remove just a little hair at a time.
5) Hair on the body of the horse can either be cut or left longer for weather protection and additional padding. Remember when clipping, that less hair is
removed when cutting with the grain; more hair is removed when cutting against the grain of the hair.
6) When you are finished, clean the clipper and oil the blades before packing it away.
SERVICES AND REPAIR (for USA purchased products only)
This appliance contains no user-serviceable parts. Wahl Service Department. Do not return this product to the store where purchased.
If you have problems with your clipper, send it prepaid with a noteexplaining the problem to:
Wahl Clipper Corporation
Attn: Service Department
3001 Locust Street / PO BOX 578
Sterling, Illinois 61081
Telephone: 1-800-PRO-WAHL or visit www.wahl.com
Sharp clipper blades cut faster. FOR GENUINE FACTORY BLADE SHARPENING, remove as a set (do not send one blade only). Blades will be re-
sharpened for a nominal charge. Please wrap blades securely when mailing them to Wahl. Return to:
Wahl Clipper Corporation
Attn: Service Department
3001 Locust Street/PO Box 578
Sterling, Illinois 61081
For products purchased in Europe, return to:
Wahl Europe
Herne Bay Trade Park
Herne Bay, Kent CT6 8JZ England
For products purchased outside the United States or Europe, contact
your distributor. New replacement blades are available from your
retail tack or pet shop or from Wahl Clipper Corporation.
LIMITED WARRANTY:
This warranty valid only for sales in the Continental United States. For sales outside of the Continental United States contact
local distributor for warranty and terms. If your Wahl product fails to operate satisfactorily within one (1) year from the date of original purchase or receipt
as a gift, Wahl will at our option repair or replace it and return it to you FREE OF CHARGE. Our warranty does not cover blades, which are wear out
parts. Please mail your product prepaid to Wahl Clipper Corporation, Sterling, Illinois 61081, Attention: Repair Department, with a Note describing the
defect and the date of original purchase or receipt as a gift (if in warranty). Products out of warranty will be repaired at our standard repair charges.The
warranty is void and no repair or replacement will be made under this warranty or otherwise if:
1) The product is modified in any manner.
2) The product is repaired by anyone other than Wahl Clipper Corporation.
3) The product has been subjected to unreasonable use.
This warranty gives specific legal rights and you may also have other rights, which may vary from state to state. No other written express warranty is
given. Any implied warranty including any warranty of merchantability, which may arise from purchase or use, is limited to the one-year period provided in
this express warranty. Some states may not allow such limitation, so it may not apply to you. No responsibility is assumed for accidental or consequential
damages of any type, or for the use of unauthorized attachments. Some states may not allow the exclusion or limitation of incidental or consequential
damages, so the limitation or exclusion may not apply to you.
Models listed in this booklet may not be available in certain voltages
and cycleages, contact your Wahl distributor for further information.
WAHL CLIPPER CORPORATION
2900 LOCUST STREET
PO BOX 578
STERLING, ILLINOIS 61081
PHONE 1-800-PRO-WAHL/ 815-625-6525
www.wahl.com
Wahl UK, Ltd
Herne Bay Trade Park
Sea Street, Herne Bay
Kent CT6 8JZ, England
Phone (44) 1227 740066
FAX (44) 1227 375636

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

9590

Table des Matières