Rear Differential Removal - Horizon Hobby LOSI 22S NO PREP DRAG ROLLER: 1/10 2WD Manuel D'utilisation

EN

REAR DIFFERENTIAL REMOVAL

1. To remove the rear differential, start by removing the two (2) rear tires using a 7mm nut
driver.
2. Remove the two (2) rear camber links.
3. Using a 2.0mm allen driver, remove the six (6) screws holding the transmission and rear
motor guard to the aluminum chassis.
4. Using a 2.0mm allen driver, remove the wheelie bar upper attachment.
5. Remove the rear body mount.
6. Remove the four (4) screws securing the transmission to the chassis, then remove the
motor guard and wheelie bar.
7. Remove the gear cover, spur gear, and slipper plates on the left side of the chassis.
8. Disconnect the three brushless motor wires from the ESC.
9. Remove the rear pivot block and rear arms.
10. Remove the transmission pass through screw, and slide the transmission out of the chassis
(lift up and back).
11. Use a 2.5mm driver to remove the motor from the transmission.
12. Remove the three (3) screws on the left side of the transmission, and remove the side
cover.
13. Slide the differential out of the transmission.
6
LOSI 22S PRO NO PREP DRAG ROLLER: 1/10 SCALE 2WD • INSTRUCTION MANUAL
®