Cleaning Tips - Kärcher K 3.97 M Mode D'emploi

WINTERIZING AND LONG-TERM STORAGE

CLEANING TIPS

Deck Cleaning
(with or without detergent)
Pre-rinse deck and surrounding area with
fresh water. If using Kärcher Deck Wash,
place detergent suction tube directly into
cleaning solution and apply to surface at
low pressure. For best results, limit your
work area to smaller sections of
approximately 25 square feet. Allow Deck
Wash to remain on surface 1-3 minutes. Do
not allow detergent to dry on surface. Rinse
at high pressure in a long sweeping motion
keeping the spray nozzle approximately 3-6
inches from the cleaning surface. Always
clean from top to bottom and from left to
right. When moving on to a new section of
the cleaning surface, be sure to overlap the
previous section to eliminate stop marks
and ensure a more even cleaning result.
House Siding
(with or without detergent)
Pre-rinse cleaning surface with fresh water.
If using Kärcher Pressure Wash, place
detergent suction tube directly into cleaning
solution and apply to surface at low
pressure (for best results, limit your work
area to sections of approximately 6 feet
and always apply detergent from bottom to
top). Allow Pressure Wash to remain on
surface 1-3 minutes. Do not allow detergent
to dry on surface, if surface appears to be
drying, simply wet down surface with fresh
water. If needed, use special Wash Brush
Attachment (not included) to remove
stubborn dirt. Rinse at high pressure from
top to bottom in an even sweeping motion
keeping the spray nozzle approximately 6
inches from the cleaning surface.
All manuals and user guides at all-guides.com
5) Cleaning the
water inlet filter
Pull out the water in-
let filter with flat-nose
pliers and rinse out in
warm water.
– continued
Cement Patios, Brick and
Stone
(with or without detergent)
Pre-rinse cleaning surface with fresh water.
If using Kärcher Pressure Wash or
Degreaser, place detergent suction tube
directly into cleaning solution and apply to
surface at low pressure. For best results,
limit your work area to smaller sections of
approximately 25 square feet. Allow
Pressure Wash or Degreaser to remain on
surface 1-3 minutes. Do not allow detergent
to dry on surface. Rinse at high pressure in
a sweeping motion keeping the spray
nozzle approximately 3-6 inches from the
cleaning surface. Always clean from top to
bottom and from left to right.
Cars, Boats & Motorcycles
(with or without detergent)
Pre-rinse vehicle with fresh water. If using
Kärcher Touchless Vehicle Wash, place
detergent suction tube directly into cleaning
solution and apply to surface at low
pressure. For best results, clean one side of
vehicle at a time and always apply
detergent from bottom to top, do not allow
detergent to dry on surface. If needed, use
special Wash Brush Attachment (not
included) to remove stubborn dirt. Rinse at
high pressure in a sweeping motion
keeping the spray nozzle approximately 6-8
inches from the cleaning surface (distance
should increase when rinsing pin-striping or
other sensitive surfaces). Always clean from
top to bottom and from left to right. For
best results, wipe surface dry with a
chamois or soft dry cloth.
Caution: Do not use the rotary nozzle on
vehicles as it may cause damage.
6) Cleaning the
detergent inlet
filter
Pull it out and rinse out
in warm water.
Maintenance
The unit is mainte-
nance-free.
9