Care And Maintenance; Warranty Conditions; Disposal (Weee) - Lavorwash Windy 165 IF Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
avoid a hazard.
If an extension cord is used, the plug and socket
must be of watertight construction.
Before vacuuming liquids, check the float functions
correctly. When vacuuming liquids, and when the
tank is full, a float closes the suction opening, and
the vacuum operation is interrupted. Then switch
off the machine, disconnect the plug and empty the
tank. Regularly clean the water level limiting device
(float) and examine it for signs of damages.
If the machine overturns, it would be recommended
to stand it up before switching off.
If foam or liquid escape from the appliance, switch
off immediately..
The equipment should not be used to vacuum
water from containers lavatories, tubs, etc.
Aggressive solvents or detergents should not be
used.
Service and repairs must be carried out by qualified
personnel only. Only use manufacturer original
spare parts for service repair.
The manufacturer cannot be held responsible for
any damage/injury caused to persons, animals or
property caused by misuse of the appliance,
USE
(see fig.②③)
• Be sure that switch is in off position (0) OFF and
connect the machine to a suitable socket.
• The machine must be always kept on horizontal
bases, in a safe and stable way.
• Insert the suitable filters for the proper use.
Never use the appliance without filters .
• Use the most suitable accessories for the requested
usage.
• Put switch on (1) ON position in order to start the
machine.
• When job is over, switch off (0) OFF and keep away
the plug from the socket.
• If the appliance is used with especially fine dust
(size below 0.3 µm) the filter supplied will require
cleaning more frequently. For especially demanding
applications, the use of specific filters supplied as an
optional (Hepa) may be necessary.
FILTER CLEANING
(see fig. ④)
•The machine shall be disconnected from its power
source, by removing the plug from the socket-
outlet, during cleaning or maintenance
1- Remove the filter N or O
2- Shake the filter N or O
3- Wash the filter N
4- Let the filter N drying very well ,befor reassemble it
•Once the filter has been cleaned, check whether it
is suitable for further use. If it has been damaged or
broken, replace it with an original filter.

CARE AND MAINTENANCE

(see fig. ④)
The unit is maintenance-free.
The machine shall be disconnected from its power
source, by removing the plug from the socket-
outlet, during cleaning or maintenance
• Clean the exterior part of the machine with a dry cloth.
• Move the appliance only by catching the carrying
handle located on the motor head.
• Store the appliance and the accessories in a dry safe
place, out of the reach of children.

WARRANTY CONDITIONS

All our machines are subjected to strict tests and are
covered against manufacturing defects in accordance
with applicable regulations. The warranty is effective
from the date of purchase.
The following are not included in the warranty: -
Parts subject to normal wear. - Rubber parts, charcoal,
filters and the accessories and optional accessories.
- Accidental damage, caused by transport, neglect or
inadequate treatment, incorrect or improper use and
installation failing - The warranty shall not cover any
cleaning operations to which the operative components
may be subjected, such as clogged nozzles and filter
blocked due to limestones. This machine is intended
to be used for domestic and hobby work: the warranty
does not cover any other different kind of use.

DISPOSAL (WEEE)

As the owner of electrical or electronic equipment,
the law (in accordance with the EU Directive 2002/96/
EC of 27 January 2003) prohibits you from disposing of
this product or its electrical / electronic accessories as
municipal solid waste and obliges you to make use of
the appropriate waste collection facilities.
The product can be disposed of by returning it to the
distributor when a new product is purchased. The new
product must be equivalent to that being disposed of.
sound pressure level : LpA = 79,1 dB(A)
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Windy 165 pfWindy 150 ifWindy 150 pf

Table des Matières