Oster OSTERIZER 6630 Manuel D'instructions page 5

A
CAUTION: Follow these important steps to assemble, tighten, and mount Blender container
quickly and correctly. INJURY MAY RESULT IF MOVING BLADES ARE EXPOSED.
1.
1. Turn container upside down so the small
opening is at the top.
2. Place sealing ring on container opening.
L
EFT
R
IGHT
S
TOP
S
TOP
A B
C
ONTAINER
L
UG
C D
Do not attempt to place the container on or attempt to remove it from the motor base while
the motor is running.
A H C
LWAYS OLD ONTAINER WITH
Y
SSEMBLING OUR
2.
3. Turn the agitator blades upside down and
place in mouth of container.
4. Thread container bottom to container.
T C
IGHTENING THE
A. To tighten container bottom, put assembled
container securely into motor base ring with
handle and lug in front of the right stop.
B. Using container handle, turn container
to the left as far as possible. This insures
that the container bottom is tightened
properly. Remove container from motor
base and mount.
C. To operate Blender, place assembled
container in motor base ring with container
lug against flat side of the motor base stop.
If container lug does not rest against flat side
of right stop, remove container assembly
and place against flat side of left stop.
Seat container firmly and operate.
D. To remove container, lift straight up.
(If it is not easily removed, rock gently and
lift up, do not twist). If container bottom
cannot be loosened by hand, place
assembled container into motor base ring
with handle in front of left side stop.
Using handle, turn container to right
until container bottom loosens.
O
NE
5
B
LENDER
3.
ONTAINER
H W P
AND HILE ROCESSING
4.
!