Settings; Changing Settings - Goobay 71362 Mode D'emploi

• The product must be attached absolutely straight.
• Plants, street lighting, reflective surfaces or randomly moving
objects must not be located in the detection range.
• The recommended mounting height is 2.2-4 m.
2. Drill a hole in size of the housing of the motion sensor into the wall or
ceiling with suitable tools.
3. Press the mounting clamps up or backwards to each other and put the
motion sensor into the prepared hole.
7

Settings

7.1

Changing settings

1. Tilt the inner part of the motion sensor on the nut by using a screwdriver.
2. Adjust the switch-off delay TIME by using a screwdriver between 10
seconds and 15 minutes.
Fig. 10: Mounting
Fig. 11: Settings
Fig. 12: Changing settings
16